Struct rp2040_pac2::i2c::regs::IcSar[][src]

#[repr(transparent)]pub struct IcSar(pub u32);

I2C Slave Address Register

Implementations

impl IcSar[src]

pub const fn ic_sar(&self) -> u16[src]

The IC_SAR holds the slave address when the I2C is operating as a slave. For 7-bit addressing, only IC_SAR[6:0] is used. This register can be written only when the I2C interface is disabled, which corresponds to the IC_ENABLE[0] register being set to 0. Writes at other times have no effect. Note: The default values cannot be any of the reserved address locations: that is, 0x00 to 0x07, or 0x78 to 0x7f. The correct operation of the device is not guaranteed if you program the IC_SAR or IC_TAR to a reserved value. Refer to <<table_I2C_firstbyte_bit_defs>> for a complete list of these reserved values.

pub fn set_ic_sar(&mut self, val: u16)[src]

The IC_SAR holds the slave address when the I2C is operating as a slave. For 7-bit addressing, only IC_SAR[6:0] is used. This register can be written only when the I2C interface is disabled, which corresponds to the IC_ENABLE[0] register being set to 0. Writes at other times have no effect. Note: The default values cannot be any of the reserved address locations: that is, 0x00 to 0x07, or 0x78 to 0x7f. The correct operation of the device is not guaranteed if you program the IC_SAR or IC_TAR to a reserved value. Refer to <<table_I2C_firstbyte_bit_defs>> for a complete list of these reserved values.

Trait Implementations

impl Clone for IcSar[src]

impl Copy for IcSar[src]

impl Default for IcSar[src]

Auto Trait Implementations

impl Send for IcSar

impl Sync for IcSar

impl Unpin for IcSar

Blanket Implementations

impl<T> Any for T where
    T: 'static + ?Sized
[src]

impl<T> Borrow<T> for T where
    T: ?Sized
[src]

impl<T> BorrowMut<T> for T where
    T: ?Sized
[src]

impl<T> From<T> for T[src]

impl<T, U> Into<U> for T where
    U: From<T>, 
[src]

impl<T, U> TryFrom<U> for T where
    U: Into<T>, 
[src]

type Error = Infallible

The type returned in the event of a conversion error.

impl<T, U> TryInto<U> for T where
    U: TryFrom<T>, 
[src]

type Error = <U as TryFrom<T>>::Error

The type returned in the event of a conversion error.